How To Repair A Plastic Bumper On A Car

Anything from a car accident to just backing into a pole tin leave a paring in your plastic bumper. An auto torso shop tin fix information technology, but why spend hundreds when you can easily exercise information technology yourself? Past following the steps below, you lot can remove and repair unsightly dents in your plastic fender, and get your car looking as good as new over again.

Step 1 - Inspect

Prior to undertaking any of the work necessary to repair the bumper dent, you should inspect it to determine the severity of the problem. Measure the perimeter of the paring and keep the information on mitt. The size of the problem may determine what method must be used to rectify it.

Step 2 - Make clean

Clean the expanse around the dent so any tools you might demand to use can work properly. For calorie-free debris, rinsing the surface with water should exist sufficient; automobile shampoo should be used for heavier soiling. In either case, use a cloth to thoroughly dry the surface after information technology has been cleaned.

Footstep iii - Utilise Heat for Small-scale Dents

When you lot have access to the area backside the bumper and the dent is a minor one, you volition find it can be fixed with the utilise of a heat gun or pilus dryer. Heat guns can achieve very high temperatures, so be sure you are wearing heat-resistant gloves, clothes, and eyewear when performing this repair. Direct the hot air from the pilus dryer or heat gun at the dented section until information technology is merely warm plenty to become pliable. Then, simply reach around to push the dent out from the rear carefully. Go out the expanse to cool when it is finally back to normal.

Step 4 - Rent Tools for Larger Harm

Tools specifically made to repair this kind of impairment are available from car accessory supply stores or can often be rented when needed. For larger dents, a plunger tool will be required. The mouth of the plunger must be firmly attached to the surface to create an airtight seal, which can exist improved by applying a little petroleum jelly to the rim. Once the plunger is correctly positioned, information technology should be held tightly and tugged backward to pull the paring out.

Another type of plunger available on the market will require a pigsty to be drilled into the center of the paring. This will enable a hooked wire to be inserted to pull the plastic back into place. When yous demand to use this tool, advisedly drill the hole so you lot merely create a recess in the bumper and do not go further than necessary.

Step 5 - Repair Cracks or Holes

If you noticed any cracks during repair, or if you lot had to drill a hole to gear up the dent, you can use a bumper repair kit to seal it. The kit should comprise all the items that y'all need, but before you purchase one, make sure y'all tin can apply it on whichever blazon of plastic your bumper is made from.

Mix the repair compound in accord with the instructions and apply it to the fissure or hole with a putty knife until it is filled completely. Even out the surface and use some sandpaper to shine information technology once it is dry.

Pace half-dozen - Touch Upward Paint

Terminate up by going over the whole repair with a proper primer and an automotive pigment that matches your specific colour. If yous're non confident you can match information technology, this concluding footstep may exist a chore you exercise have to go out to the pros. Make sure you take intendance of this as soon equally possible, however, because rust tin can quickly take over areas without a protective finish.